![]() ![]() I haven't been able to find anything in the knowledgebase yet. When I request it on the member that needs it, it tells me the command is invalid. I tested, and it does the same thing when I request a firmware upgrade for member 3 (which does not exist). Note that when I request the firmware upgrade for a member that doesn't need it, it tells me it couldn't initiate the firmware upgrade. Member 0 is revision 7, member 1 is revision 5, and member 2 is revision 3. Unable to initiate firmware third member is 'new'. ![]() Invalid upgrade request system firmware upgrade poe fpc-slot 1 This procedure will take around 10 minutes (recommended to be performed during request system firmware upgrade poe fpc-slot 2 Use 'request system firmware upgrade poe fpc-slot ' Member ID for next new member: 3 (FPC show poe controllerĬontroller Maximum Power Guard Management Status LldpĠ 100.00W 18.00W 0W Class AT_MODE Disabledġ 100.00W 12.20W 0W Class AT_MODE DisabledĢ** 100.00W 0.00W 0W Class AT_MODE Disabled When I run 'show poe controller', it tells me a firmware upgrade is available, but when I try to apply it, it tells me the upgrade command is show virtual-chassis It uses the copy stored in the /var/sw/pkg directory. I have three EX2200c switches in a virtual chassis. Use this command to revert to the last successfully installed package before the request system software (add delete) command. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |